2.9.0 (201704121101): Sequential Subcontrols issue

Question

I'm noticing when I use 2 sequential subcontrols the supercontrol works correctly. When I add a 3rd sequential  subcontrol the values around the transition area are, i.e. the max value of #2 and the min values of #3 are not consistent..

Are there any limitations with the number of sequential subcontrols that can be used?

FYI, my subcontrols are set to bank/program change. I wanted to make one slider for four banks of program changes. The fix was 2 sets of "2 sequential subcontrols with 1 supercontrol. The 2 supercontrols are then subcontrols for one supercontrol. That's the only way I could get it to work correctly.

Comments

FYI, I tried adding and removing values on the sub's as well as the super. At times I received inconsistent results.

---

Byron so you're saying that following the example provided in 5329 exactly, you can't get that example to work? Thanks.

---

That's correct. I had my slider set to Bank/Program Change. Not sure that would make a difference.

---

sorry, slider is super or slider is subcontrol?

---

Slider used on sub and super