LAYOUT: Meris Enzo controls and presetsby mitchelldr

Question

Gold

MIDI Target Manufacturer(s): Meris

Here is a layout for the new Meris pedal. Layout  should work on channel 7.

I added a presets pages specifically for the Enzo this time, this page recalls the presets saved on the pedal therefor you're MD layout will not update with the settings of the pedal.   I have solved this problem by writing rules in Stream Byter to update the layout with the settings from the pedal when you send a SysEx dump.  You can send a Sysex dump by holding alt and mode buttons on the Enzo and this should show the controls on the layout.  

There is also an option to save and recall presets from the MD layout, this will not change presets on the pedal.   The difference between the two kinds of presets is the presets stored to the iPad are stored in MD and the presets on the left panel page are stored to the 16 built in presets on the meris pedals. 
  
 

Downloads: 3085
Enzo2.0.mididesigner - Updated with Stream Byter rules to parse sysex data. The layout should update after receiving sysex dumps with your saved settings.
Downloads: 1866

Enzo1.1.mididesigner - Okay this one should fix the issues the bass player was having with the layout!
Downloads: 1219

Images

Screenshot

Comments

Hey Patrik, so unfortunately I did write the stream byter rules for channel 7 only.  You would have to rewrite the rule in SB to work on channel 8.  I'll keep this in mind when writing rules for SB in the future. Thanks,
Mitch

---

Awesome layout! How can I change the midi channel on this?

---

You can change the MIDI channel if you have the extra features pack by going into design mode, selecting the Enzo tab to pull up Page controls and clicking Renumber Controls on the controls tab.  Then select Channel only when you select the channel you want to use.  
The Stream Byter rules are somewhat more difficult to change as they are written in a sort of coded language and those will not change with the reset of the layout.

---

ok thanks for the info :)

---

I changed the channel for all controls.  I would like to change the channel to channel 13 for the Stream Byter input rules.  I understand SB reasonably well, but I'm not great with parsing the MIDI bytes - I have to think very hard about them and look them up.  If someone could tell me a simple way to do this conversion for these rules I would appreciate that.  Thanks!